Skip to content

Raspberry Pi Pico / RP2040 / RP2350

On the Pico family, MicroPython is not loaded via serial bootloader, but via USB storage in BOOTSEL mode.

Procedure

  1. Hold BOOTSEL and connect the board to USB.
  2. The RPI-RP2 disk will appear on the computer.
  3. In the installer, download the correct .uf2 file for the selected board.
  4. Copy .uf2 to the attached disk.
  5. The board will restart itself after copying.
  6. Continue to upload libraries in the installer.

Tips

  • The same principle applies to Pico, Pico W, Pico 2 and other RP2040/RP2350 variants.
  • When the RPI-RP2 drive does not show up, the problem is that BOOTSEL was not held when connected.
  • Always perform a reset after flashing and only then upload libraries.

What is copied after installation

The installer will add boot.py, main.py and libraries according to instalace_new/rp2/files.lst after the reset.